2002 EAGLE Technology. All rights reserved
eagle@eagle.co.za

Tel: +27 21 423 4943
Fax: +27 21 424 4637
Tollfree: 0800 233322 (SA only)



 
Conga XTX Starterkit

This is a complete kit to start the evaluation of XTX modules immediately

It contains:

  • conga-XEVAL Evaluation Baseboard
  • conga-Xdebug Post-Code and debug card
  • ATX power supply with cables
  • CD-ROM drive
  • USB Memory Stick 128 MByte
  • conga-XDVI DVI evalutation platform
  • Cable set for IDE, SATA, Floppy Drives
  • Cooling Fan
  • congatec software tools
  • Quick Installation Guide

conga-XEVAL

Evaluaton Board for XTX Modules

To achieve a quick start with XTX congatec offers an evaluation baseboard, which routes all the ETX and XTX signals to standard interface connectors. With this you're able to check out all of the innovative XTX features and your specific expansions immediately.

I/O

  • 2x PCI Express
  • 2x Express Card Socket
  • 4x 32 Bit PCI
  • 1x PS/2 Keyboard & Mouse
  • 10/100 Ethernet
  • 6x USB (2 routed to Express Card Sockets)
  • IrDA connector
  • COM 3 + 4 via baseboard Super I/O
  • LPT2 via baseboard Super I/O

Storage

  • 2x IDE (master/slave), 4x SATA

Audio

  • Line In/Out (stereo)
  • Mic In (mono)
  • Additional AC'97 Audio Codec
    • SPDIF optical
    • Line In/Out (stereo)
    • Mic In (mono)

Video

  • Composit Video Out
  • S-Video Out
  • LCD Interface

Additional

  • Error code speaker
  • User Data EEPROM on IC Bus
  • PCI Posrt Postcode Display
  • XTX misc. signal feature connector
  • 2x LPC Flash Socket
  • Mounting holes for DVI adapter
  • Fan connector

Power

  • AT and ATX power supply connectors
  • Additional 5V Power Supply Jack
  • Power-On and Reset Buttons
  • Onboard CMOS Battery

conga-Xdebug

XTX Debug Platform

The conga-Xdebug provides a debug platform for your application specific baseboard. Simply use it as a transparent debug interface between your baseboard and the XTX module.

Postcode Display

  • configurable
  • can display LPC or PCI postcode

LPC Firmware Hub Flash (FWH)

  • helps to evaluate customized BIOS versions

1x SATA Connector

  • provides access to a SATA device

Power Connector

  • for baseboard independent operation

VGA / Keyboard / Mouse / COM / USB

  • peripheral connector that provide full debug capabilities

Power and Reset Buttons

LED's

  • 4x Status LED's connected to GPIO
  • 4x Status LED's for Command Byte
  • Enable (CBE), which show the PCI bus activity

conga-XDVI

XTX Evaluation Platform for DVO/SDVO/DVI-D

The starter kit (conga-XKIT) includes the conga-XDVI, which provides the ability to evaluate both the DVO and SDVO features found on congatec's XTX modules. It's fully supported by the congatec Embeeded BIOS and features the following chips:

DVO to DVI-D

  • Silicon Image SiL164

SDVO to 2xDVI-D

  • Silicon Image SiL1362
  • Chrontel CH7307C