... is currently empty.
 GO
  Access Control System
 
  Avionics Buses
 
  CCTV Security
 
  CCTV Surplus
 
  Components
 
  Data Acquisition
 
  Device Programmers
 
  Displays
 
  Home Appliances
 
  Industrial Communication Products
 
  Industrial Computers
 
  Laser Distance Measuring
 
  Motion Control
 
  Power Supplies
 
  RF & Microwave
 
  Rugged Tablet
 
  Sensors
 
  Surplus Products
 
  Test & Measurement
 
  Visitor Management System
 
  Weather Station
 
 




 
Industrial Computers > VME Bus > Pentium
Rugged Pentium M VMEbus

Rugged, Full-Featured Pentium M VMEbus Module

Pentium M Processor:

  • 2 MB of L2 Advanced Transfer Cache
  • Available in either the Ultra Low Voltage 1.0 GHz, 5 W version or the Low Voltage at 1.3 GHz,10 W version


  • Single-slot Operation
  • Single-slot VMEbus operation with an on-board CompactFlash disk for bootable mass storage.


  • 855GME and 6300ESB Chipset
  • 400 MHz System Bus
  • Ultra ATA 100/66/33 IDE protocol
  • PCI-X expansion offers 64 bits @ 66 MHz data transfer capability.
  • Integrated Graphics
  • Chipset includes DRAM controller, USB 2.0 interface, two Serial ATA/150 ports, RTC, NV-RAM, standard PC timers, Ultra DMA, and interrupt logic.


  • DRAM
  • DDR-266 support with a memory bandwidth of 2.1 GB/s
  • Stuffing options for 256MByte, 512MByte or 1GByte


  • VMEbus
  • Tundra Universe IID PCI-VMEbus interface provides
  • Full range of software drivers is available for different
  • Full Slot 1 (system controller) functions provided
  • Lower cost versions available without VMEbus


  • PMC Expansion
  • One PMCX site with 64 bit @ 66 MHz bandwidth is available on-board
  • I/O is routed through the P2 connector (on the outer rows, D and Z) as well as through the front panel.


  • Ethernet
  • An Intel 82546 Ethernet controller supports two 10/100/1000BaseTX Ethernet ports routed to the P0 connector in compliance with Vita 31.1 for backplane fabric switching or for alternate routing to an optional rear I/O card
  • An 82559 provides one 10/100BaseTX port that is accessible from the front panel.


  • Graphics
  • 6300ESB I/O Controller Hub provides an integrated 32-bit 3D core at 133 MHz.
  • SVGA and one 12-bit DVI is accessible at the front panel via a high-density DVI -I connector.
  • SVGA and 12-bit DVI interfaces are routed through P0 when no front panel I/O is installed.


  • IDE
  • Primary ATA/100 DMA IDE interface is accessible from the VMEbus P2 connector.
  • PIO and bus master support
  • Secondary IDE port is routed to a Type II compatible CompactFlash connector for on-board booting


  • BIOS
  • General Software's flash-based system BIOS with a variety of boot options including CD-ROM and PXE over Ethernet.
  • Customized versions can be provided


  • Watchdog
  • Programmable watchdog timer for system recovery
  • I/O interfaces accessible from the front panel
  • VGA/DVI, Dual USB, 10/100BaseTX port, and COM1


  • I/O interfaces accessible from optional rear plug-in expansion card
  • IDE and PMC I/O (routed through P2)
  • LPC interface runs through P2 so the rear plug-in module can produce standard PC I/O like
  • COM1/2 ports, Floppy Disk Controller, Mouse/Keyboard interface and LPT1 through an LPC compatible device.
  • Optionally COM2 and two distinct USB 2.0 ports may be routed through P2 instead of the LPC interface that cannot use a rear plug-in card.
  • Two Serial ATA ports, two 10/100/1000BaseTX ports, and a VGA/DVI port (routed through P0).


  • Rugged Versions Available
  • Wedge locks and conduction cooled in compliance with IEEE 1101.2
  • Expanded temperature range and high shock & vibe operating characteristics


  • Power Requirements
  • TBD
  • The RPM is a VMEbus (and VME64) compatible platform based on the low power Pentium M (Dothan) processor. The RPM takes advantage of the Pentium Mís low power consumption as a rugged Single Board Computer (SBC) and it is optionally available as an IEEE 1101.2 compliant conduction-cooled VMEbus module with wedge locks and a full-board heat sink for high shock/vibration environments and temperature extremes.

    The 855GME and 6300ESB chipset supports PCI-X expansion, integrated VGA, DVO, USB 2.0, ATA/100, and Serial ATA. A VGA/DVI connector, two USB ports, a 10/100BaseTX interface and a COM port are all accessible from the front panel. On-board CompactFlash permits single-slot booting. Two Vita 31.1 compliant 1000BaseTX ports are routed to the backplane.

    Conventional PC I/O is accessible with industry standard connectors on optional rear I/O modules as well as Serial ATA, VGA/DVI Video, GB Ethernet, and two more USB 2.0 ports. One PMCX site is provided for additional I/O expansion.

    For more information on the Rugged, Full-Featured Pentium M VME bus Module, as well as pricing: Contact Alan Bearman at Eagle Technology


    ©2003 EAGLE Technology. All rights reserved.  Home | Contact | Sitemap | Free email newsletter | Career Opportunities