Conga XTX Starterkit This is a complete kit to start the evaluation of XTX modules immediately It contains:
- conga-XEVAL Evaluation Baseboard
- conga-Xdebug Post-Code and debug card
- ATX power supply with cables
- CD-ROM drive
- USB Memory Stick 128 MByte
- conga-XDVI DVI evalutation platform
- Cable set for IDE, SATA, Floppy Drives
- Cooling Fan
- congatec software tools
- Quick Installation Guide
conga-XEVAL
Evaluaton Board for XTX Modules
To achieve a quick start with XTX congatec offers an evaluation baseboard, which routes all the ETX and XTX signals to standard interface connectors. With this you're able to check out all of the innovative XTX features and your specific expansions immediately.
I/O
- 2x PCI Express
- 2x Express Card Socket
- 4x 32 Bit PCI
- 1x PS/2 Keyboard & Mouse
- 10/100 Ethernet
- 6x USB (2 routed to Express Card Sockets)
- IrDA connector
- COM 3 + 4 via baseboard Super I/O
- LPT2 via baseboard Super I/O
Storage
- 2x IDE (master/slave), 4x SATA
Audio
- Line In/Out (stereo)
- Mic In (mono)
- Additional AC'97 Audio Codec
- SPDIF optical
- Line In/Out (stereo)
- Mic In (mono)
Video
- Composit Video Out
- S-Video Out
- LCD Interface
Additional
- Error code speaker
- User Data EEPROM on I²C Bus
- PCI Posrt Postcode Display
- XTX misc. signal feature connector
- 2x LPC Flash Socket
- Mounting holes for DVI adapter
- Fan connector
Power
- AT and ATX power supply connectors
- Additional 5V Power Supply Jack
- Power-On and Reset Buttons
- Onboard CMOS Battery
conga-Xdebug
XTX Debug Platform
The conga-Xdebug provides a debug platform for your application specific baseboard. Simply use it as a transparent debug interface between your baseboard and the XTX module.
Postcode Display
- configurable
- can display LPC or PCI postcode
LPC Firmware Hub Flash (FWH)
- helps to evaluate customized BIOS versions
1x SATA Connector
- provides access to a SATA device
Power Connector
- for baseboard independent operation
VGA / Keyboard / Mouse / COM / USB
- peripheral connector that provide full debug capabilities
Power and Reset Buttons
LED's
- 4x Status LED's connected to GPIO
- 4x Status LED's for Command Byte
- Enable (CBE), which show the PCI bus activity
conga-XDVI
XTX Evaluation Platform for DVO/SDVO/DVI-D
The starter kit (conga-XKIT) includes the conga-XDVI, which provides the ability to evaluate both the DVO and SDVO features found on congatec's XTX modules. It's fully supported by the congatec Embeeded BIOS and features the following chips:
DVO to DVI-D
SDVO to 2xDVI-D
- Silicon Image SiL1362
- Chrontel CH7307C
|